Electrical supply project for an apartment, house, cottage is an individual approach to organizing the power supply of a dwelling. In most cases, an electrical project is made up on the basis of project design of the interior, in which it is already determined where and which electrical consumers are located. The source document for calculating the load is the “Act of delimitation of the balance sheet ownership of power plants”, which the owner of the housing must receive from the operating organization (DEZ). In another way, this document is called “Certificate of permitted power for an apartment or house.” Thus, the electrical project of an apartment or house provides for drawings on which energy consumers and systems for protecting residents from electric shock are located, calculations of loads on the electrical network that do not exceed the permitted one. When the power supply project is completed, it must be agreed. In the case when the homeowner wants to increase the permitted capacity, coordination with the owner of the networks and the power supply is required. The electrical project has been agreed, it is possible to proceed with the installation work, upon completion, proceed to the next stage, during which tests (measurements) of electrical installations are made. This work is performed by a licensed organization and, upon completion, draws up a technical report. Our “thorny” path in the operation service (DEZ) is coming to an end, where we bring the project of the apartment’s electricians and the technical report. Based on these documents, we obtain a permit for operation.
Coordination of the power supply project must be done while working on the design of your housing so that the total power of the electrical products and equipment you have chosen does not exceed the allocated power for the apartment. As a rule, many residential buildings are put into operation without connecting electricity to the apartments, and the allocated electrical power for the entire house is divided between consumers. Therefore, an Electrical Project made by an Architect (Room Designer) for your home needs to be approved. The project indicates the type of wires and their cross-sections, approves the fundamental location of certain electrical routes, draws the routes for the location of wires from the shield to consumers.